User's Manual

This equipment complies with Part 24 of the FCC rules. Any changes or modifications
not expressly approved by the manufacturer could void the user's authority to operate the
equipment.
In order to comply with FCC rules for RF exposure, it must be observed that the antenna
connected to this equipment be fixed on an outdoor structure and that it must have a
minimum separation distance of 10 meters between it and any person.
In accordance with Industry Canada RSS-131, the manufacturer's rated output power of
this equipment is for single carrier operation. For situations when multiple carrier signals
are present, the rating would have to be reduced by 3.5 dB, especially where the output
signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at
the output of the device.
PCS block filters must be installed to achieve compliance with part 24 spurious emission
limits. Filters are manufactured by Clearcomm Technologies, part number CCFA-174-
XX . Connect the output filter port marked “BTS “ with the port on By-Pass module
marked “To BTS Duplexer”. Connect the filter port marked “ANT” to the By-Pass
module port marked “ From ANT Duplexer”. Connect the filter port marked “AMP
OUT” with corresponding attenuator port on Gain Control module. Connect filter port
marked “AMP IN” to the Amplifier module port marked “ RF OUT”.