User's Manual

100141-INST Cell Extender Model CE-1819-10G2 Page 4 of 5
Rev. - 05/2007 User Manual and Installation Instructions
USING THE REMOTE POWER MODULE (Option 3)
The Remote Power Module allows the Cell Extender to be powered remotely over the coax line, thus
eliminating the need to run AC or alarm wires up the mounting structure to the unit. The Remote Power
Module is typically installed next to the BTS equipment and sits in-between the BTS and the Cell
Extender. With Option 3, the AC and ALARM connectors are no longer available on the Cell Extender,
but are now located on the Remote Power Module. The pinouts of these connectors remain the same. It
is also important NOT to mix the FEEDER A and FEEDER B lines (ie, make sure that the coax feeder
line hooked up to the FEEDER A connector on the Remote Power Module is ALSO hooked up to the
FEEDER A connector on the Cell Extender.
Diagram 2 – Remote Power Module (Option 3)