User Manual

Additional Information
Communication Components Inc. PCS GSM Multi-Channel Cell Extender
The Cell Extender is specifically designed for compatibility with the a variety Micro Base Sta-
tion Equipment and is guaranteed to maintain the integrity of the GSM signal upon amplifica-
tion. This is achieved by utilizing state-of-the-art LDMOS technology for power amplification,
monolithic Gallium-Arsenide technology low noise receive amplification, with particular empha-
sis on low system group delay to minimize Bit-Error-Rate (BER) of digital transmissions.
The Cell Extender block consists of a single compact unit with two RF connectors and a single
AC line for power. It is housed in a moisture proof NEMA 4X aluminum die-cast enclosure with
integrated heat sinks and is suitable for either outdoor or indoor installations. The Cell Ex-
tender is designed to boost two pre-combined GSM or EDGE channels that are provided from
the Micro Base Station. It contains redundant low noise amplifiers to boost the receive signals,
redundant LDMOS-based high power amplifiers to boost the transmit signal, dual duplexers,
an integrated power supply and alarm/control circuitry to monitor the operation of the unit. The
Cell Extender is powered by a conventional 110/220 VAC source or can be optionally DC-
powered via the Coax cable using the Remote Power Option.
Options
♦ 01: Additional Rx Only Channel
♦ 02: Monitoring Interface
♦ 03: Remote Power Option (with Internal Bias-T)
♦ AD: A & D Power Operation
♦ B: B Band Operation
♦ C: C Band Operation
♦ EF: E & F Band Operation
Ordering Information
♦ Model CE-1819-10
Communication Components Inc.
Tel: [phone] Fax: [phone]
FCC Information
A minimum separation distance of 2 meters between the transmit antenna and nearby persons
must be maintained. If this separation distance is not maintained, this device may not be in
compliance with FCC RF Exposure rules.