User's Manual

AGC in the uplink amplifier is factory preset at the gain that corresponds to the
intermodulation products level of -13 dBm. If the signal level is low and AGC light is not
"ON", slowly increase the gain of the downlink amplifier until the light will be lit. Back
off the potentiometer just below the level when the light is off.
Check the security of the installation and presence of the AC power. Amplifier is ready
for operation.
3. REMOVE BI-DIRECTIONAL AMPLIFIER
3.1 Unplug the AC cord from the socket. AC light on the amplifier must be off.
Disconnect all coaxial cables.
3.2 Dismount amplifier from the wall or remove it from the shelf.
4. SHIPMENT AND STORAGE OF THE BDA
4.1 Use common technical shop practices to ensure equipment protection during shipment
or storage.
5. TROUBLESHOOTING AND FAULT DETECTION
5.1 Check the presence of the AC power. The AC light must be on.
5.2 Check the continuity of all connecting cables.
5.3 If the fault was not located, remove the amplifier and send it to the manufacturer for
repair.
5.4 RF testing of the amplifier is possible in the specially equipped laboratory.
6. INFORMATION TO USER
This equipment complies with part 15 of the FCC rules. Any changes or
modifications to this product as well as usage outside of specified electrical
parameters, which are not expressly approved by manufacturer, could void the
user’s authority to operate the equipment.
WARNING!
110 VAC CAN BE LETHAL!
ALWAYS UNPLUG THE AMPLIFIER
BEFORE SERVICING THE INTERIOR.
.