User's Manual

Page#2 of 2
• Adjust the input power level to insure the output power level is in compliance
with the values indicated in the table on page 2.
Setting the RF Output Power on the BDA-1819-10 Booster Amplifier
The RF output power is not adjustable on the PCS PICO CELL Booster Amplifier. The
user must adjust the RF input power to the PCS PICO CELL Amplifier such that the
RF output power level does not exceed the levels shown below in order for the RF
output spectral emissions to be compliant with the FCC spurious emissions limit of -
13 dBm outside of the assigned frequency block.
Channel Center Frequency
(MHz)
Maximum RF 0utput
(Watt)*
1930.2-1989.8 10
* Note: The Maximum RF Output Power is after any passive losses after the Booster Amplifier such as
filters and cables.
This equipment complies with Part 24 of the FCC rules. Any changes or
modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
In order to comply with FCC rules for RF exposure, it must be observed that the
antenna connected to this equipment be fixed on an outdoor structure and that it
must have a minimum separation distance of 3 meters between it and any
person."
This equipment has been tested for single channel operation only and should not
be used for multi-carrier operation.