User's Manual

Page 3 of 34
1 Preface
1.1 Disclaimer
This document may be revised without prior notice. For most recent releases, visit our website or contact
support. Please send any comments or remarks about this document to [e-mail]
(including the document title in the subject). Commsignia Inc. reserves all rights to this document and the
information contained herein. Products, names, logos and designs described may in whole or in part be
subject to intellectual property rights.
Note: Any changes or modifications made to this device that are not expressly approved by Commsignia
Inc. may void the user's authority to operate the equipment.
Note: Confidential - This document is provided in confidence and may not be used for any purpose other
than that for which it is supplied. All content within may not be disclosed to any third party or used for other
purpose without the written permission of Commsignia Ltd.
FCC compliance statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter must be at least 20 cm from the user and must not be co#located or operating in conjunction
with any other antenna or transmitter.
1.2 Document Changelog
This section is a reference to the iterative changes in the document listed by issue number.
Table 1: Changes in the document
Issue number
Changes
1-1
Added information about the NTP configuration.
1-0
This is the first issue of the document.
CONFIDENTIAL - BACL Corp. - 04/28/2018