User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 5 Troubleshooting
S1000C User Guide, Release 1.5 5-5
DR
AFT
4G DATA LEDs
Figure 5-3 shows the quick reference
for data LED functions.
Figure 5-3. 4G
Solid Green: WiFi service UP
Solid Red: HW/WiFi service problem
Blinking Red: Wifi service error
Off: Wifi service or service disabled
Solid Green: LTE service UP
Solid Red: HW/LTE service problem
Blinking Red: LTE service error
Off: LTE service sector disabled
Solid Green: GPS Time Fix available
Solid Red: HW/GPS Time Fix
problem
Blinking Red: GPS Time Fix not
available
Solid Green: Ready
Solid Red: HW/connection problem
Blinking Red: IPSec tunnel error
Solid Green: Ready
Solid Red: HW/connection problem
Blinking Red: Service error
Data LEDs quick reference