User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 3 Configuring the S1000C Router
3-14 913114 1.5.01 August 2016
DR
AFT
Adding your ISP User Name and Password
If you are using a DSL modem and your device cannot connect to the Internet, you
may need to enter your ISP account user name and password so that the S1000C can
connect to the Internet.
You will use the User Interface of the S1000C
internal router to configure this
information.
TIP
Before you begin, obtain your ISP user name and password. Contact your ISP if
you do not have this information.
1 Log into the S1000C router by following the procedure in Logging in to the
S1000C router.
2 Click the Setup
tab on the Router status page menu bar.
3 Click W
AN Settings.
4 Ensure that Yes (PPPoE) is selected.
5 Enter your ISP user name in the Login box and your password in the Password
box. Select authentication type (PAP, CHAP) from the drop down menu. Enter the
Service name information if you have it. Click OK.