User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Table 3-6. Advanced Settings parameters
Parameter Description
Beacon Interval Specifies the time in which a beacon packet
must be broadcast.
By default, all the SSIDs will be
beaconing at an interval of
100msec. (Range: 50 msec to 3500 msec)
Transmit Power This defines the strength of the signal being transmitted from a
radio.
By default, both the radios will be transmitting at th
e highest
Transmit Power.
Block Dynamic Frequency
Selection (DFS) Channels
This option allows the Auto Channel Selection (ACS) mechanism
to either select/unselect DFS channels.
The following channels are classified as DFS channels:
52,56
,60,64,100,104,108,112,116,120,124,128,132,136,140
By default, the 5GHz radio will block all the DFS channels. One
can enable the use of these channels by unchecking the checkbox
and applying the settings.
NOTE: It is NOT recommended to use these channels.
Chapter 3 Configuring the S1000C Router
3-12 913114 1.5.01 August 2016
DR
AFT
MAC Address Filtering
This feature is used to ALLOW or BLOCK MAC addresses from associating with a
Private SSID.
By default, this feature is DISABLED on every Private SS
ID.