User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 3 Configuring the S1000C Router
S1000C User Guide, Release 1.5 3-11
DR
AFT
Advanced Settings
On the WiFi Advanced Setup page you can configure some WiFi advanced parameters
such
as Beacon Interval, Transmit Power and Block DFS channel. Generally no
configuration change is required on this page.
Figure 3-5. Advanced Settings page
Starting IP The starting range of the reserved pool of IP Addresses for this
SSID.
Ending IP The ending range of the reserved pool of IP Addresses for this
SSID.
Edit
Click this button to edit the configuration for the SSID.
Lan Interface Details
SSID
Note: All parameters described above apply to the SSID
for the Local Area Network (LAN).
Default DMZ Server When checked, the IP Address for this “Demilitarized zone” is the
default server. The IP Address can be configured.
Note: Use this cautiously, as there are security issues
associated with a DMZ server.
Apply Click this button to commit the DMS server configuration.
Table 3-5. LAN IP Setup parameters (continued)
Parameter Description