User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 3 Configuring the S1000C Router
S1000C User Guide, Release 1.5 3-7
DR
AFT
Multiple SSID Setup
The S1000C router supports twelve SSIDs. Eight SSIDs are Private and user
configurable; four are Public and c
onfigured only by the Operator.
1 Click Multiple SS
ID Setup.
NOTE: Public SSIDs can only be enabled or disabled in the S1000 Router. Public
SSIDs are configured from the DMS Device Management Portal under Device
Configuration. Refer to DMS Device Management Portal User Guide for S1000
Devices (913157) for details.
Figure 3-2. Multiple SSID Setup page
Table 3-3. Multiple SSID List parameters
Parameter Description
SSID The name of the network to which a device associates
Enable To enable/disable a SSID, check/uncheck the box for the SSID. Click
Apply.
Status Shows the status of a SSID per Radio