User's Guide

Table Of Contents
Chapter 1 Troubleshooting
S1000 User Guide, Release 1.0 19
DR
AFT
Resetting the S1000
If your S1000 operates properly for an extended period and the WAN LED suddenly
starts blinking red, the S1000 may have a problem requiring a reset. To reset the
S1000, push the Reset button for at least 10 seconds (as shown in the drawing below).
After resetting, your S1000 goes through
an automated setup sequence. During this
time, the device's green LEDs will be solid for a few seconds, and then all LEDs will
turn off until the software loads. The reset process may take
30-45 minutes.
After resetting the S1000, if the failure
persists, contact Customer Care. See Getting
help o
n page 1-27.
S1000