Users Manual Part 2

Appendix D Field Replaceable Units
OneCell
®
Hardware Installation, Release 4.5 D-47
D
R
A
F
T
7 Replace the cover on the RP.
8 Verify the RP installation. The operational state of the RP can be determined by
the LED status on the RP. Additional information can be attained from the
WebGUI status screens.
For verification procedures, see RP post-replacement verification.
Replacing RP5100i RF modules
The following procedures provide instructions for replacing a OneCell Radio Point
RF module.
WARNING
Disconnect the Ethernet cable(s) on the RP to remove the power. Failure to do so
will cause damage the RP.