Installation Instructions

Chapter 5 Configuring the OneCell system
OneCell
®
Installation and Commissioning, RP5000 series, Release 4.0 5-21
D
R
A
F
T
BC State Active – Active member of the cluster
StandBy – StandBy member of the cluster
Virtual Cell ID A unique ID used to tie LTE service parameters together on a
Baseband Controller running in Active mode in a cluster.
Note: This field is mandatory if Active State is selected.
Operator Configuration – Security Gateway 1 Configuration
Security Gateway FQDN/IP
Address
The Baseband Controller establishes a secure tunnel connection
with this gateway for S1 or OAM traffic.
IP address <A.B.C.D> or FQDN
Address Type Static – When set to Static, the user/operator should define a
static Tunnel Inner Address for the S1 tunnel
Dynamic – When configured Dynamic - the address is
dynamically assigned by the Security Gateway during IKE
processing
Tunnel Inner Address Tunnel IP Address provided by the Security Gateway after
successful session establishment
<A.B.C.D>
Tunnel CIDR CIDR format [1 - 32]
Tunnel Internal DNS IP Address <A.B.C.D>
Exclude Configuration Payload
(CP)
True – Configuration Payload is excluded during IKE
processing.
False – Configuration Payload is included during IKE
processing.
Operator Configuration – Security Gateway 2 Configuration
Security Gateway FQDN/IP
Address
The Baseband Controller establishes a secure tunnel connection
with this gateway for S1 or OAM traffic.
IP address <A.B.C.D> or FQDN
Address Type Static – When set to Static, the user/operator should define a
static Tunnel Inner Address for the S1 tunnel
Dynamic – When configured Dynamic - the address is
dynamically assigned by the Security Gateway during IKE
processing
Tunnel Inner Address Tunnel IP Address provided by the Security Gateway after
successful session establishment
<A.B.C.D>
Tunnel CIDR CIDR format [1 - 32]
Table 5-2. Baseband Controller operator parameters, configuration file
Parameter Description