Installation Instructions

Chapter 5 Configuring the OneCell system
5-2 913035 4.0.04 June 2019
D
R
A
F
T
Overview
Once the Baseband Controller and Radio Point are installed and connected, you will
need to configure the OneCell system. Logging onto the BC for the first time opens
the Web GUI in Installation Mode. This chapter contains the procedures for initial
configuration. For more information about the Installation mode, see OneCell
®
Administration (913026)
In preparation of configuring the OneCell system:
Use the Controller GUI, called the Web GUI, to configure all components, except
the Ethernet switches
Confirm with the operator that the Baseband Controller is provisioned and
configured on the DMS
Configuring the Baseband Controller using the Web GUI completes the Baseband
Configuration. Once the Baseband Controller and Ethernet switches configurations
are complete, go to
Chapter 6, Verifying the OneCell installation to test the installation
and initial configuration.