Installation Instructions

Chapter 6 Verifying the OneCell installation
OneCell
®
Installation and Commissioning, RP5000 series, Release 4.0 6-7
DR
AFT
Figure 6-5. Service Status
Table 6-3. Service Status
Parameter Description
MME Connection YES – The Baseband Controller has S1AP connection with the
MM
E.
NO – The Baseband Controller does not have
S1AP connection
with the MME.
Configuration from HeMS YES – The Baseband Controller has received the required
conf
iguration from HeMS
NO – The Baseband Controller has not received the configuration
from HeMS.
Number of IPSec Tunnels None - tunnel mode is Non IPSec
One - tunnel mode is Single IPSec Tunnel
Two - tunnel mode is Dual IPSec Tunnel
IPSec Connection Status YES - A secure connection is established with
the Security Gateway
NO - No secure connection exists with the
Security Gateway
NON IPSec - The connection does not use IPSec.
Dual Ipsec - The connection uses both OAM
and S1 IPSec
connections.
IPSec Tunnel (per Tunnel 1
, Tunnel 2 or Non IPSec)
IPSec Connection Status ENABLED – Tunnel is established an
d connected
DISABLED – Tunnel is n
ot established
ERROR – Error occurred during tunnel establishment
Security Gateway Address IP Address of the Security Gateway through which the tunnel is
established
Tunnel Internal Address Tunnel IP address provided by the Secu
rity Gateway after successful
session establishment.
<A.B.C.D>