Installation Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- Document revision history
- About this document
Chapter 1 CommScope ONECELL® overview
ONECELL
®
RP5200 Hardware Installation, Release 5.5 1-3
D
R
A
F
T
Figure 1-1. ONECELL solution
ONECELL hardware components
The ONECELL hardware consists of the following components:
• Baseband Controller
— Baseband Controller Chassis
— Baseband Controller Module
— Power/Fan Unit (PFU)
• Radio Points
— RP2000 series
— RP5000 series
Baseband Controller physical ports
The following ports are on the front panel of the Baseband Controller Module.
Table 1-1 shows the port assignments. In addition, there is a connector used for the
GPS antenna cable.
NOTE
For more detailed BC port information, see ONECELL
®
Network Planning Guide,
v5.5 (M0304AF).