User's Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Part I: Overview and preparation
- Airvana OneCell overview
- Preparing to install the OneCell system
- Part II: OneCell component installation
- Baseband Controller installation
- Radio Point Installation
- Part III: Appendices
- Safety
- Specifications
- Installation troubleshooting
Appendix C Installation troubleshooting
C-4 913020 10.05 April 2015
D
R
A
F
T
Radio Point LED patterns
The Radio Point has one LED on the front cover. The following table shows
• Display pattern for the LED
• What the pattern indicates
• Action to take, if any, to resolve the issue
LED Display Pattern Indicates Action to Take
STATUS Green, solid Power On
RFTx state is on
None
Amber, solid Self-test failure
Green, blinking Firmware upgrade
Connected to Controller
None
Amber, blinking PLL state – unlock
RFTx State – off or suspended
L2 path verification failed
AdminState – STANDBY
Red, blinking No connection to Controller
(http)
Red, solid Error in system – software or
hardware issues
Interface issues detected
AdminState – UNLOCKED