User's Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Part I: Overview and preparation
- Airvana OneCell overview
- Preparing to install the OneCell system
- Part II: OneCell component installation
- Baseband Controller installation
- Radio Point Installation
- Part III: Appendices
- Safety
- Specifications
- Installation troubleshooting
Chapter 4 Radio Point Installation
4-4 913020 10.05 April 2015
DR
AFT
Mounting the Radio Point on the ceiling tile
1 Remove ceiling tile from the overhead.
2 Cut 5” diameter hole to fit a 4-inch octagon box and drill a 1/2” diameter hole for the Ethernet
cable pass-through.
NOTE: Use a 1-1/2 deep RACO 8125 or equivalent.
TIP
Trace the outline of the octagon box on the ceiling tile.
Use the mounting plate as a guide on the ceiling tile.