User's Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Part I: Overview and preparation
- Airvana OneCell overview
- Preparing to install the OneCell system
- Part II: OneCell component installation
- Baseband Controller installation
- Radio Point Installation
- Part III: Appendices
- Safety
- Specifications
- Installation troubleshooting
Chapter 4 Radio Point Installation
4-2 913020 10.05 April 2015
D
R
A
F
T
Radio Point installation overview
There are four configurations for installing the Radio Point, which are dependent on
the ceiling type.
• Ceiling mount, on tile
• Ceiling mount, above tile
•Flown mount
•Pole mount
Ceiling mount
Mounting the Radio Point (RP) above or on the ceiling tile requires the following
hardware provided by Airvana:
• Radio Point plate and screws
• Mounting plate screws
Figure 4-1. Airvana ceiling mount kit contents
Mounting the Radio Point (RP) above or on the ceiling tile requires the following
hardware provided by the system integrator:
• 4" octagon box, 1-1/2" deep with 1/2" side cutouts
• Drop rail – Eaton B-line BA50 recommended
•Clamp
• Mounting screw
Radio Point plate
with four screws
Mounting plate with
two screws