User's Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Part I: Overview and preparation
- Airvana OneCell overview
- Preparing to install the OneCell system
- Part II: OneCell component installation
- Baseband Controller installation
- Radio Point Installation
- Part III: Appendices
- Safety
- Specifications
- Installation troubleshooting
Chapter 3 Baseband Controller installation
3-4 913020 10.05 April 2015
D
R
A
F
T
5 Secure the CU by tightening the front panel screws.
6 In the back of the rack, carefully slide the PFU into the back of the chassis.
CAUTION
The PFU has a fan hazard. A label is affixed to the top of the PFU indicating the
hazard.
NOTE: The connectors on the PFU should fit easily into the connector on the CU.
Do not force the PFU into the chassis.
Fan hazard label