User's Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Part I: Overview and preparation
- Airvana OneCell overview
- Preparing to install the OneCell system
- Part II: OneCell component installation
- Baseband Controller installation
- Radio Point Installation
- Part III: Appendices
- Safety
- Specifications
- Installation troubleshooting
Chapter 1 Airvana OneCell overview
1-4 913020 10.05 April 2015
D
R
A
F
T
Controller ports
The following ports are on the front panel of the Controller Unit.
• 12 Ethernet - ports 0-10 and MGMT; 7-10 are dual media ports
• 6 fiber optic - Ports 7-12
In addition, there is a connector used for the GPS antenna cable.
Figure 1-2. Controller ports
Port Number Description
Ethernet
MGMT VLAN #80 – used for remote management of the OneCell system
through a CLI
1-4 VLAN #10 – IQ data connection between the Controller and Radio
Point through an Ethernet switch
5 VLAN #30 – used for IPsec through a WAN connected to an Ethernet
switch
6-7 VLAN #1 – used for timing and SOAP/XML control data connected to
an Ethernet switch
8-10 Future use
Fiber Optic
7-12 Future use