User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Appendix A l
ADCC connector specifications
A-4 910136 Rev01.00 Standard July 2007
NOTE
The T1/E1 ports are not supported in this release of the ipBTS.
Table A-6. T1/E1 connector pin assignments
Pin Function I/O
1 RX- (Ring) I
2RX+ (Tip) I
3N/C
4TX- (Ring) 0
5TX+ (Tip) O
6N/C
7N/C
8N/C
Table A-7. 100BaseT connector pin assignments
Pin Function I/O
1TX+ O
2TX- O
3RX+ I
4N/C
5N/C
6RX- I
7N/C
8N/C