User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Appendix A l
Module physical specifications
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 A-3
Module physical specifications
Table A-4 describes individual ipBTS module dimensions and weights.
ADCC connector specifications
Table A-6, Table A-6, and Table A-7 provide the provide the specifications and pin out
assignments for the GPS antenna, RJ-48C and RJ-45 100BaseT connectors located on the front
of the ADCC module.
Table A-4. Module specifications
Module Specifications
ADCC module Weight 5.6 lbs (2.5 kg)
Height 17.5 inches (444.5 mm)
Length 15.0 inches (381 mm)
Depth 1.2 inches (30.48 mm)
RM
(Radio Module)
Weight 5.6 lbs (2.5 kg)
Height 17.5 inches (444.5 mm)
Length 15.0 inches (381 mm)
Depth 3.8 inches (96.52 mm)
Table A-5. GPS antenna specifications
Function Specification
Frequency 1.57542 GHz (L1)
Impedance 50 ohms
Input level -135 dBm and -115 dBm as measured with 50 ohms
DC power supplied to GPS antenna
using the center conduit
+5VDC, +/- 0.1VDC, 25 mA maximum