User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 A-1
Appendix A
RN Specifications
This appendix provides specifications for the ipBTS. It contains the following sections:
• Physical and environmental specifications on page A-1
• Power specifications on page A-2
• Module specifications on page A-3
• T1/E1 connector pin assignments on page A-3
• 100BaseT connector pin assignments on page A-4
• Craft port interface pin assignments on page A-5
Physical and environmental specifications
Table A-1describes the ipBTS physical and environmental requirements.
Table A-1. Physical and environmental specifications
Specification Description
Weight Maximum weight 35 lbs. (15.8 kg)
Dimensions of chassis Height 3.5 in. (8.8 cm)
Width 17.5 in. (44.5 cm)
Depth 18.5 in.s (47 cm)
Operating temperature
range
Normal
5
°C to 40°C
Short term
-5
°C to 50°C
Relative humidity Normal 5% to 85%
Short term 5% to 90%