User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 4 l RN commissioning
Updating node software
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 4-23
Figure 4-3. Establishing an SSH connection
The following displays indicating a CLI/SSH session is active:
ipBts-XXX>
Updating node software
This section describes how to verify the node’s software version and, if necessary, update the
software.
Verifying the current release and free disk space
The following procedure shows you how to use the CLI to verify the currently active software
release on the node, how to verify the amount of free disk space on the node, and how to
remove files if more free space is needed before transferring a new release to the node. The
procedure assumes that you have an active CLI session.
If there is no need to update the node’s software release the ipBTS commissioning is complete.
NOTE
The node’s software release can be updated later from a centralized network location using
the ipBTS C30 user interface or the CLI through an SSH session.