User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 4 l RN commissioning
Verifying SNTP time
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 4-11
Verifying SNTP time
Follow this procedure to verify the ipBTS C30 is receiving the correct timing information from
the BTS.
1. From the CLI console, enter ipBts-XXX> show sntp time to display the current
UTC time and output similar to this:
Sntp Time Details - UTC
Timing Source = 10.10.50.4
Base Secs = 3219347575 (bfe35877)
Base Nsecs = 820540580 (30e874a4)
Base TBH = 11 (0000000b)
Base TBL = 3003409790 (b304657e)
Current Secs = 3219347773 (bfe3593d)
Current Nsecs = 863521250 (337849e2)
Num Leap Secs (since 1980) = 13
Date = 2007:1:6
Time = 23:16:13.863
2. Verify that the date and time are correct.
Commissioning the ipBTS C30
This section describes how to configure the ipBTS C30 using the Commissioning script.
Specifically, it contains the following section:
• Using the Commissioning script on page 4-11
Using the Commissioning script
Follow this procedure to configure the ipBTS C30 using the Commissioning script.
For more information about the Commissioning script, contact your network planner.
1. Download the Commissioning script from your laptop to the ipBTS C30’s disk0:/
config directory.
2. From the tool-bar, select the CLI button.
3. Press <Enter>.
The ipBts-XXX> prompt displays and indicates you are in EXEC Mode.
4. Enter the following commands to enter Privileged EXEC Mode and run the
Commissioning script (<script_filename>).
ipBts-XXX> enable
ipBts-XXX# copy disk0:/config/<script_filename>
system:running-config