User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 4 l RN commissioning
Connecting the laptop to the ipBTS C30
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 4-7
Connecting the laptop to the ipBTS C30
Follow this procedure to establish a serial connection between your laptop and the ipBTS C30.
1. Verify the ipBTS C30 is powered on. (See Table 3 on page 1-8.)
• If the ipBTS C30 is powered on, continue with step 2.
2. Connect one end of the RS-232 serial cable to your laptop’s serial port and the other end to
the ipBTS C30’s serial port.
3. Power on your laptop..
Sectors sectorIndex The index of the sector to which this SectorElement is bound. Range: {1..65535}.
Note: The SectorIndex can be changed only when the status of this
SectorElement object is down (1).
sector Latitude North The geographic latitude of the center of the antenna array serving the sector.
Range: {-90,000 to 90,000} 1/1000 of a degree North and South of Equator.
When configuring this attribute from the EMS, a negative value denotes South
and positive denotes North. When configuring from the CLI, specify North or
South. Default (0).
sector Longitude East The longitude of the center of the antenna array serving this sector. {-180,000 to
180,000} 1/1000 of a degree East and West of the Prime Meridian.When
configuring this attribute from the EMS, a negative value denotes West and
positive denotes East. When configuring from the CLI, specify East or West.
Default (0).
Carriers ChannelNumber The channel number within the BandClass on which the carrier is to operate. The
default value is (2047).
CellRadius The size of the cell corresponding to the SectorElement, specified in chips.
Range: {0...512} with the default value (0).
AccessCycleDuration The access cycle duration, measured in slots. Values: (8, 16, 32, 64, 128) with the
default value (64).
Modem Mode The mode of the modem. Range: unknown (1), other (2), oneCarrierOneSector
(3), oneCarrierThreeSector (4), twoCarrierBiSectorOmni (5).
ipBTS C30 OperStatus The operational status of the ipBTS C30. Range: unknown (1), other (2), down
(3), up (4), test (5), fault (6).
AdminStatus The administrative status. Range: down (1), up (2), test (3).
LastChangeTime The last time the operational status changed.
RNC Priority The priority of the RNC. Range: {0..1000} with the default (0).
Table 4-3. Configuration parameters (continued)
Object Parameter Description