User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 3 l ipBTS C30 installation
Powering on the RN
3-10 910136 Rev01.00 Standard July 2007
ADCC LED indicators
There are seven indicator LEDs on the front of the ADCC module. The LEDs provide the
following status information:
• POWER - On (green) indicates bulk power is available to the module.
• RESET - On (green) indicates the module is in a reset state.
• OOS - On (red) indicates the module is Out Of Service due to fault or not ready.
• CRITICAL - Summary alarm: Critical
• MAJOR - Summary alarm: Major
• MINOR - Summary alarm: Minor
• GPS LOCK - On (green) indicates the GPS receiver is in a locked state.
10/100 Ethernet backhaul
Two LED indicators on the RJ45 connector provide the following information:
• LNK - On (green) indicates that Link is established.
• ACT - On (green) indicates transmit and receive activity.
Radio module LED indicators
There are three indicator LEDs on the front of each radio module. The LEDs provide the
following status information:
• POWER - On (green) indicates bulk power is available to the module.
• RESET - On (green) indicates the module is in a reset state.
• OOS - On (red) indicates the module is Out Of Service due to fault or not ready.