User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Contents
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 xi
Transferring software from the laptop to the node ........................................................ 4-25
Requirements .......................................................................................................... 4-25
Procedure ................................................................................................................ 4-25
Activating the new release............................................................................................. 4-26
Chapter 5
RN hardware components
RN shelf components .............................................................................................................. 5-1
ADCC module ................................................................................................................. 5-1
Radio module................................................................................................................... 5-2
Fan trays........................................................................................................................... 5-2
Air filter ........................................................................................................................... 5-3
Appendix A
RN Specifications
Physical and environmental specifications ............................................................................ A-1
Power specifications .............................................................................................................. A-2
Input power interfaces .................................................................................................... A-2
Module physical specifications.............................................................................................. A-3
ADCC connector specifications............................................................................................. A-3
ADCC craft port interface............................................................................................... A-4
Radio module specifications .................................................................................................. A-5
Appendix B
Hot-swapping ipBTS hardware
Replacing a Radio module ......................................................................................................B-1
Replacing an ADCC module...................................................................................................B-3
Replacing a fan in the RN shelf ..............................................................................................B-4
Replacing the air filter.............................................................................................................B-5
RMA process...........................................................................................................................B-7
Index