User's Manual

IP-RN 8000 I&C Guide 105
2. Locate the antenna access panel on the cabinet where you will install the Rox System.
There are four antenna access panels. The Rox System can be installed into any one of the cabinet
openings created when the access panels are removed.
The standard configuration requires installing the Rox System into the access panel on the top of the
back of the cabinet.
NOTE
Installing the Rox System cabinet seal into any of the three non-standard access
panels requires a different internal configuration of the cabinet, and it must have
been specially ordered.
3. Remove the 10 screws from the antenna access panel with the tamper-proof screwdriver, being careful
not to let the access panel fall when the final screw is removed.
CAUTION
!
Access panels must be handled carefully. If they are bent they may not form a
proper seal with the cabinet when they are re-installed. An intact seal on the inside
edge of the access panel is required to ensure external environmental conditions
are sealed out.
Non-standard Rox System installation panels
Standard Rox System cabinet seal installation panel