User Manual

Testing primary power
IP-RN 8000 Installation & Commissioning Guide 69
Testing primary power
This procedure explains how to test whether power is applied to the IP-RN 8000, whether the voltage is at
the correct nominal level at the cabinet’s power terminals, and whether power is distributed internally.
Be sure you have read and understood Understanding the cabinet installation process
on page 50 before
continuing.
Requirements
No tools are required.
Procedure
1. Open the front door and visually examine the compartment for loose wires or components.
2. Pull the backhaul cable(s) ends forward and through the power terminal access panel.
CAUTION
Take all appropriate safety precautions before closing the main
circuit breaker and turning on power. Failure to do so can result in
personal injury and equipment damage.
CAUTION
Do not perform this procedure in the raid or injury or death may
occur.
CAUTION
All connections must be tight and all components secured before
continuing. Loose connections or components can cause short
circuits and injure or kill nearby persons and damage equipment.
WARNING
Pulling the backhaul cable ends out of the cabinet through the
power terminal access panel is necessary to prevent short circuits,
to prevent danger, and protect equipment.