User Manual

Chapter 4 ● Installing the cabinet, power, and ground
62 Release 2.0, 910056 Rev01d
Bolting the cabinet in place
This procedure explains how to bolt the cabinet onto the concrete insulation pad.
Be sure you have read and understood Understanding the cabinet installation process
on page 50 before
continuing.
Requirements
• Open ended wrench of appropriate size for your anchor bolt nuts
• Four washers, lock washers, and nuts for the anchor bolts embedded in the concrete pad
These are not provided by Airvana but are specified by the site planner.
Procedure
1. Look through the removed left side access panel and the backed away right side access panel and find
the four anchoring bolts sticking up from the concrete pad through holes in the cabinet base.
2. Using the four washers, lock washers and nuts, thread a washer, lock washer and nut onto each anchor
bolt.
3. Use an appropriately sized open ended wrench to tighten the four nuts.
This procedure is complete. Go to Re-installing the left side access panel
on page 63
Rubber insulation
pad visible from
all sides