User Manual

Chapter 4 ● Installing the cabinet, power, and ground
54 Release 2.0, 910056 Rev01d
Unpacking the cabinet from its shipping container
This procedure explains how to unpack the cabinet from its shipping container.
Be sure you have read and understood Understanding the cabinet installation process
on page 50 before
continuing.
Requirements
• 5/8 inch open ended wrench
• Slotted screwdriver
Procedure
1. Familiarize yourself with the shipping crate.
The IP-RN 8000 is shipped as follows: it is bolted to a palette, covered with a plastic bag, and wooden
sides and a top are attached with metal snaps. Additional material may be shipped in boxes tucked
beneath the cabinet door.
2. Using a slotted screwdriver, remove the metal snaps that hold the wooden top of the shipping cabinet in
place.
To remove the snaps:
a. Insert the screwdriver behind the half of the snap that has a wedge shaped relief for it, and hold the
other half of the snap against the cabinet with your open hand.
b. Gently pry the snap away from the cabinet until it releases.
3. Lift the wooden top off.
CAUTION
Hold the snap as you pry it off. Otherwise, the snap may fly into
the air when it is pried off.