User Manual

Understanding the Sector Radio Kit and the Antenna Interface Unit
IP-RN 8000 Installation & Commissioning Guide 15
Table 9 Radio Module (RM) faceplate components
Component Description
Latches and screws Top and bottom latches Close to insert the RM in its slot.
Open to remove the RM from its slot.
Captive screws Tighten to secure the module into its slot.
Loosen before removing the RM from its slot.
LEDs Power Lights green when the RM is receiving power. Flashes during
module initialization.
Alarm Lights red when the RM is in an alarm state.
Interfaces RX0 Connects to the RX0 interface for this radio sector on the
AIU. Carries one of two received RF signals. Connector type:
SMA receptacle (female).
RX1 Connects to the RX1 interface for this radio sector on the
AIU. Carries one of two received RF signals. Connector type:
SMA receptacle (female).
RX0 (Sample) Provides a receiver injection port for use with externally
connected mobile test radios or test equipment. Connector
type: SMA receptacle (female).
RX1 (Sample) Provides a receiver injection port for use with externally
connected mobile test radios or test equipment. Connector
type: SMA receptacle (female).
TX output to PA Connects transient RF signals to/from the PA module using
Airvana cable installed during the installation process. Also
carries control information to the PA and status information
from the PA to the RM. Connector type: SMA receptacle.
Contour type: blind mate.
Craft/serial port Connects to a management PC for CLI access to the RM.
DB-9 interface. The serial port speed is 115,200 bit/second.
For information on the DB-9 pin-out, see Table 35 on
page 196.
Reset button Recessed button Pressing this recessed button resets the RM processor.