User Manual

Chapter 6 ● Connecting antennas
98 Release 2.0, 910056 Rev01d
If your deployment uses three antenna cables per sector, connect the cables to the connectors as follows:
2. First finger tighten the RF and GPS antenna cables to the correct surge suppressor connectors on the top
side of the surge protection bar inside the cabinet.
CAUTION
All antenna cables dangling inside the cabinet must be connected
to the surge suppressor connectors, even if they are not connected
to antennas externally. Failure to connect all cables could result in
equipment damage and loss of EMI protection.
Surge suppression bar — top view from the rear
Gamma (χ)
sector
Beta (β)
sector
Alpha (α)
sector
RX1
Unused
TX/RX0 RX1 Unused
TX/RX0
RX1
Unused
TX/RX0
Primary GPSSecondary GPS
Cable connections with two RF cables per sector
Gamma (χ)
sector
Beta (β)
sector
Alpha (α)
sector
RX1
RX0
TX RX1 RX0
TX
RX1
RX0
TX
Primary GPSSecondary GPS
Surge suppression bar — top view from the rear
Cable connections with three RF cables per sector