User Manual

Chapter 6 ● Connecting antennas
92 Release 2.0, 910056 Rev01d
3. Remove the 10 screws from the antenna access panel with the tamper-proof screwdriver, being careful
not to let the access panel fall when the final screw is removed.
4. Set aside the 10 antenna access panel screws and washers.
The screws and washers will be required for installing the Rox System cabinet seal.
The antenna access panel cover that you just removed will not be required for this installation. Save it
for later use as appropriate.
5. Locate the surge protection access panel.
CAUTION
Access panels must be handled carefully. If they are bent they
may not form a proper seal with the cabinet when they are
re-installed. An intact seal on the inside edge of the access panel
is required to ensure external environmental conditions are sealed
out.
Non-standard Rox System installation panels
Standard Rox System cabinet seal installation panel