User Manual

Re-installing the access panels
IP-RN 8000 Installation & Commissioning Guide 83
Re-installing the access panels
This procedure explains how to re-install the backhaul access panel and the power terminal access panel.
Be sure you have read and understood Understanding the backhaul installation process
on page 74 before
continuing.
Requirements
• Number 2 Phillips head screwdriver
Procedure
1. Retrieve the three Phillips head screws and the punch block access panel previously set aside.
2. Hold the panel in place over the back haul punch block and start the three screws by hand.
3. Tighten the three screws snugly. Do not over tighten or you might strip the screw threads.
4. Re-install the power cable access panel.
Go to Re-installing the power terminal access panel
on page 205.
This procedure is complete. Go to Understanding the antenna installation process
on page 86.
WRIST
STRAP
Wear an ESD strap and connect the strap to the ESD jack in he
Antenna Interface Unit when performing any installation
procedure. See Understanding the Antenna Interface Unit module
on page 17.