User manual

7. Advanced System Operation
CommPact User Manual
25
Codes 26-27: Limited Codes
A limited code enables you to issue a code that is valid for one day only. This code
automatically expires 24 hours after it has been programmed.
Code 28: Duress Code
The duress code is designed for situations where you are being forced to operate the
system. This user code grants access to the selected operation, while sending a Duress
event message to the monitoring service.
Code 29: Telecontrol Code
The Telecontrol code is designed to enable the user to perform a number of tasks via
their telephone. Using this code, the user can call their system to arm and disarm the
system, activate and deactivate PGM output, cancel the siren or establish Two-Way
Audio communication.
Editing User Codes
User code editing is a feature that is available exclusively to the master code. To
maintain a high level of security, keep all user codes confidential.
To edit a user code:
1. From the main menu select, User Codes [4].
2. Select the code you want to edit;
3. From the code’s sub-menu, select Edit Code; the 4-digit code is displayed
with the cursor flashing on the first digit.
4. Edit the code.
5. Press
; the new code is stored in the memory.
If you enter a code that is identical to an existing user code, the Control System
sounds an error tone and the new code is not accepted. 0000 is not a valid user
code as this value is used to delete a user code.
Deleting User Codes
As an additional security measure, make certain that you delete any extra codes that are
no longer required.
To delete a user code:
1. From the main menu select, User Codes [4].
2. Select the code you want to delete;
3. From the code’s sub-menu, select Edit Code; the 4-digit code is displayed
with the cursor flashing on the first digit.
4. Enter 0000.
5. Press
; the code is deleted.
The master code cannot be deleted.