User manual

6. Telecontrol

CommPact User Manual

Do not enter your user code until you hear the two tones. Any digits entered

before the tones are sounded are disregarded by the system.

3. A tone is sounded to indicate that the system is ready to receive commands.

The following commands are available:

• Press “2” for Two-Way Audio.

If the TWA mode is defined as “Simplex” (see p. 22 6.5.

Simplex Mode.), the audio channel opens in Listen mode

(microphone active/speaker mute). To switch to Speak mode,

press “1” on your telephone. To switch back to Listen mode,

press “0” on your telephone.

During the TWA session, you can adjust the speaker

volume using the arrow buttons.

• Press “3" to fully arm the system.

• Press "430" to activate PGM output (Unit 30)

• Press "530" to deactivate PGM output (Unit 30)

• Press “6” to disarm the system.

• Press “9” to cancel the siren.

4. The duration of the call is an option programmed by your installer. Ten

seconds before the end of the call, two short tones are sounded. To extend

the call, press “7” on your telephone.

5. To disconnect before the end of the call, press “*” then “#” on your

telephone.

Siren Muting

The siren is muted during Two-Way Audio communication. At the end of the call, the

siren is re-activated (if the Siren Cut-Off has not yet expired). You can cancel the re-

activation of the siren by pressing “9” on your telephone during the call.

The Arm/Disarm, PGM on/off, and Siren canceling can

also be executed at any time during a Two-Way Audio

session.

Error beeps (three tones) sound in case of a wrong

command.

To clear the last command, press “*” or “#”.