User manual

3. Arming and Disarming
CommPact User Manual
11
Arming with the Keyfob
The default functions for B1 is part arming and for B2 -- perimeter arming.
To arm the system using the keyfob:
• Press the relevant button/buttons on your keyfob (see below); the exit
delay begins to count down. At the end of the exit delay, the system is
armed.
Combination arming
There is an option to activate two arming modes simultaneously.
The possible combinations are:
• Full + perimeter
• Part + Perimeter
For combination arming, activate the first arming mode, and, while the exit delay of the
first arming mode is counting down, activate the second arming mode. It is not
important which arming mode you choose first.
It is not possible to activate Full and Part arming modes simultaneously.
It is necessary to disarm first when changing from one arming mode to another
arming mode.
Forced Arming
Forced arming enables you to arm when the system is not ready. For example, if a door
protected by a magnetic contact is open, you may arm the system on condition that the
door will be closed by the end of the Exit delay. If the door is still open after the exit
delay expires, an alarm is generated.
Forced arming is available only if the option is enabled in programming.
Instant Arming
Instant arming is a feature that allows you to cancel the entry delay after Part or
Perimeter arming the system. For this feature to function, it must be enabled in
programming by your installer.
To instantly arm the system.
1. Check if the system is ready to arm.
2. Press the Part or Perimeter arming button on the keypad (enter your user
code if required).
3. Press and hold down
 on your keypad until the message Instant Arming, OK?
is displayed
4. Press ; the entry delay for the current arming period is canceled.