Service manual

MECHANICAL DISASSEMBLY (Continued)
5. To remove the home position sensor:
5.1
5.2
5.3
Remove the sensor PCB screw.
De-solder the wire connections
from the wiring harness PCB. (See
wiring diagram on page 28).
Slide the sensor PCB toward the
front of the mechanism, pulling it
from its bracket. Turn it sideways
to fit between the carriage pillars.
6. To remove the paper feed motor assembly:
6.1
6.2
Remove the 3 motor bracket screws
from the right side -Frame assembly.
De-solder
the wire connections from
the wiring harness PCB. (See wiring
diagram on page 28).
7. To remove
the carriage position sensor and carriage motor:
7.1 Remove the sensor PCB screw and de-
solder
the wire connections from the
wiring harness PCB. (See wiring
diagram on page 28).
7.2 Remove the carriage motor screw as in-
dicated. Detach the carriage
motor and
its holder by carefully bending the
bracket legs to release them from the
base.
7.3 De-solder the motor wires from the wir-
ing harness PCB. (See wiring harness
on page
28).
HEAD
CARRIAGE
MOTOR
7.2
REMOVE
SCREW
31