User`s manual
Appendix
A
Pans
of
the text are printed too far
to
the left.
Your printer is having problems with the print optimizing factor. The
solutions in
the
previous point can
be
used here as
well.
Wide blank spaces between unrecognizable print lines.
The problem could
be
an extta formfeed.
This
problem occurs especially
with the MPS-1230. See Section 2, topic "Printer Adjustments", which
explains
how
to switch off the
form
feed.
Perhaps your printer is set to IBM
mode,
so
you
may
try
"LQA
mM
9"
(9
pins) or"LQA mM
24"
(24
pins).
Small blank spaces between good print lines.
You
may
be
using
the
wrong
printer driver or the
wrong
printer adaptation.
Try a
"SG"
driver
or
the
printer adaptation
file
"LQA
Oldmechanic".
No
form feed. Everything prints on the
same
line.
You're probably using a printer driver or an adaptation for
the
newest Epson
24
pin printers, which won't work
on
your printer. So don't use
"BpN"
drivers
(new
Epson),
use
"Bps"
or
"NEC"
instead.
With
the Print System,
use
the adaptation file
"LQA
Epson
Q"
or
"LQA
NEC
24"
instead
of
the
"LQA
NEW
Epson
Q"
file.
Minimal horizontal movement
of
the print line.
Your printer is probably printing bi-directional. Tum
this
option off using
the
DIP switches
..
The
end of the page Is not on the perforation.
Using the DIP switches,
set"
the printer to
11
inch page length. In the Print
System you
may
also copy
the
parameter
me
"LQP
11
inch" onto your
worlc
disk.
Headers and footers of the first page are not printed.
You've chosen the "title page" option in geoWrite. The Print System will
not print the headers or footers in the
first page
if
this
is
the case.
Go
baclc
to geoWrite and
tum
this option off.
56