User`s manual
The
GEOS
LQ
Print
System
These values set defaults for the print menu options (see Section
4,
topic
"Starting the Print System", sUbtopic "The Print Menu"). Generally
speaking, 24 pin mode can always be on (yes). The Print System will detect
the presence
of
a 9 pin adaptation file and switch automatically.
Page size
;**
Page
size
Yes,
Yes
;
Automatic
page
sizing
(X/Y)?
This should always
be
left as "yes, yes". The Print System
then
works out
the correct enlargement factors for the chosen print resolution and multiplies
them with the following factors.
1.0,1.0
;
(0.1-20.0)
Additional
factor
(X/Y)
;
with
automatic
on
With these factors you are able to enlarge or reduce the printout using other
factors.
IT,
for instance, you replace the fust value with 2.0, the printout
will
be
twice as wide.
1.0,1.0
;
(0.1-20.0)
Factor
(X/Y)
with
;
automatic
switched
off
IT
the automatic page adaptation value is set to "no", the Print System uses
the factors here and does not care about the resolution. The result is a
reduction in higher resolutions.
Fonts
;**
Fonts:
Yes
Allow
use
of
larger
fonts?
GEOS LQ can only use larger point sizes
if
this question is answered with
"yes". A "no" answer only allows the use
of
the original font point size.
The printout is then similar to that
of
an HQ printer driver.
No,
No
Allow
only
a
whole
number
enlargement
;
(X/Y)
?
No,
No ;
Allow
only
a
whole
number
reduction
;
(X/Y)
?
0.5,
0.5
;
Correction
amount
for
rounding
font
;
factors
if
"yes"
is
chosen
The enlargement
or
reduction
of
fonts in whole number factors is hereby
forced. This is very similar to the sizing option in the print menu, but is
separated from the
X/Y
values. The correction amount (they are the same for
35