User`s manual
Section
4
9
pin
Printers
If
you
are using a serially connected 9 pin printer,
no
additional files are
normally required, and you can begin to prinL
If
the printout results are
incorrect, then
it
is likely that
you
will need one
of
the following files
which are
located
on
page
two
of the
GEOS
LQ
program
disk:
LQConnect
S7
LQConnect
S4
LQConnect
GC
for use with
many
of
the serially connected Seikosha
SP-xxxVC printers. Check to
make sure the printer is
switched to
the ASCn mode using the DIP
switches~
for use with the MPS-1230. (see Section 2, topic
"Printer Adjustments")
for parallel connected 9 pin printers (user
port to
printer).
Note:
In
addition
to
the
file "LQConnect GC", parallel connected MPS-l000
printers
also
require the file
"LQA
mM
9"
located
on
page 3 of the deskTop.
24
pin
Printers.
24 pin printers (the Seikosha SL-80VC falls under the 9 pin printer
category) need one
of
the following files, which are found on page four
of
the
GEOS
LQ
program disk:
-
"LQA
Epson
Q"
for
EpsOn
printers ("LQA
NEW
Epson
Q"
is only for
-the
newest Epson printers and not usable on the LQ-400.)
-
"LQA
NEC
24"
for most all other 24 pin printers.
- ''LQA
mM
24"
for
mM
compatible printers (rare).
If
your
24
pin printer is serially connected, you probably won't
need
any
other files.
If
your printout is incorrect you will probably require an
additional "LQConnect" file located on page
two
of
the program disk. Try
out "LQConnect SI", "LQConnect
S4"
and "LQConnect S7" to find one
that
works.
Parallel connected
24
pin printers need to have the "LQConnect
OC"
on the
worlcdisk.
20