User`s manual

Section 4
The GEOS LQ Print System
About the GEOS LQ Print System
The GEOS LQ Print System expands geoWrite's printing capabilities and
allows adjustment
of the print quality. The system is usually started from
within geoWrite by first clicking "update" in the file menu and then
"StartLQ"
in the geos menu. Remember that only text which has been
formatted with an
LQ font will be printed out in the maximum quality.
You'll need, therefore, at least one LQ font on your work disk.
Simplified Installation
If you want to get right into producing better printouts, follow the steps in
this topic. Should
you have trouble with the installation, refer to the topics
"Making a
Work Disk" and "Printer Adaptation". Mter you have installed
the system successfully, see the topic "Using the GEOS LQ Print System"
for additional information
on system usage.
Perfect Print's GEOS LQ Print System requires much more disk space than
an
HQ driver. We recommend that you fonnat a new work disk for the Print
System, especially
if you're using a 1541 disk drive. On this work disk
you'll need "geoWrite", "deskTop" (or an alternate user interface) and the
following
mes from the GEOS LQ Print System disk:
- "GeosLQ"
- "StartLQ"
- at least one LQ font (i.e., "RomaLQ")
Depending upon your printer and how it is connected, you may also need
one or two additional files to adapt the system to your printer. If so, make
sure that you place only one "LQConnect" and one "LQA" file ("A" for
printer Adaptation)
on your work disk.
Please note that the Print System is entirely independent from the HQ
drivers, and does not use them or any other GEOS printer drivers.
If the Print System appears to lock-up when tested, it may possibly be
waiting for a parallel printer which is not connected. Pressing the "q" key on
your keyboard will remedy this situation.
19