User`s manual
Section
3
9
pin
Printers
For a 9 pin printer (including Seikosha SL-80VC)
it
is best to
use
a clriver
from page two on the desktop.
If
your printer is serially connected, then one
of
the following drivers will
be
correct:
HQ9
med Eps S5 for most Epson compatible printers with an internal
or
external (Xetec, Cardco, Supra) serial interface.
HQ9
med IBM S5 for most IBM compatible printers with an internal
or
external serial interface.
HQ9
med Eps S4 for
the
MPS-1230 (see Section
2,
topic "Printer
Adjustments,
SUbtopic
"The
Serial
MPS-1230
Printer")
HQ9
med Eps S7 for most other printers with built in serial connection
including Seikosha SP-xxxVC (remember
to change
to
ASCn
mode using
DIP
switches)
If
you're not sure which
of
these drivers is correct for your printer, try each
until
one works.
If
your printer is connected with a parallel connection, then
one
of
the
following drivers should be correct:
HQ9
med Eps GC for most Epson compatible 9 pin printers which are
parallel connected (user port connection compatible
with "geoCable")
HQ
9 med IBM
GC
for most IBM com'patible printers and the
MPS-lOOO
printer using parallel connection.
24
pin Printers
Drivers located on page four
of
the desktop
are
for use here.
If
your printer is
serial connected, then use one
of
these drivers:
HQ24
low Eps S5 for most printers with an external
or
internal serial
interface.
HQ24
low Eps S7
for
most
other
printers
with a
built
in serial
connection.
If
you're not sure which
of
these drivers is the correct one, then try each
until one works.
10