User`s manual

Section 1
The standard package is contained on two double-sided 1541 disks. The lllSt
disk contains the GEOS LQ Print System and five
LQ fonts and the second
contains the HQ printer drivers with HQ fonts and two additional
LQ fonts.
The complete package is contained on six double-sided 1541 disks.
The lllSt
two are identical with the standard package and the other four contain the
collection
of LQ fonts.
Perfect Print LQ and GEOS 128
The GEOS LQ Print System operates with GEOS 128 in both 40 and 80
column modes. This is also the case with the accessories. In both modes,
the 2
MHz processor mode is used, doubling the calculating speed. This is
only noticeable with faster 24 pin printers.
The font utilities operate in 40 column mode only.
Backup Copies
We strongly recommend you make back-up copies of all your original
Perfect Print
LQ disks. The disks are not copy-protected, as both the author
and the staff
of CMD dislike such protection schemes which hinder the legal
user's ability to make backups. Please
do not abuse this service to make
pirate copies. This is not only unethical
but also illegal. Remember to
protect your originals by covering the write-protect notch with tape before
copying. Proceed with copying, following the instructions in your GEOS
manual.
If errors occur in copying, please contact CMD for replacemenL
Acknowledgements
We wish to thank those authors and graphic designers who helped put
Perfect Print
LQ together. First and foremost, many thanks to author and
project coordinator Thilo Herrmann, who has worked long and hard not only
on the original program for Germany,
but who also dedicated many long
hours in translating the package for English-speaking countries.
Most
of the fonts were created by Kurt Pruefer, but others by Thomas
Feucht, Prof. Helmut Siebert, Denis Doehler, Heiko Lauer, Hartmut
Karrasch, Thomas Breier and Thilo Herrmann ..
The printer driver disk was
put together by Dieter Marten.
This manual was translated from German to English by Richard Gaudet,
Austria
Thanks also to Richard for bringing this product to the attention of
CMD. Editing
of the manual was performed at CMD by Doug Cotton.
4