Instructions

Routine Maintenance
HEPA Component
Follow the figure to remove the HEPA component and clean it.
Side Brush
Remove and clean the side brush regularly.
Boundary Sensor
Clean the boundary sensor with soft cloth regularly.
Rolling Brush
1. Turn over the lower clip to remove the cover for the middle motor;
2. Take out the rolling rush and clean the bearing;
3. Clean the rolling brush;
4. Reinstall the rolling brush and fasten the clip of the cover.
Note: Replace the rolling brush every 6-12 months to ensure the
cleaning effect.
Cover for middle motor
Clip
Rolling brush
Bearing
Boundary sensor
Replace the HEPA component every three months as it is not
wash able;
Clean the HEPA component with cleaning brush regularly to avoid
blockage;
Replace the side brush every three months to ensure the cleaning
effect.
14
Routine Maintenance
1. Open the top cover to take out the dustbin,as shown
in the figure.
2. Open the HEPA component; take it ou t and empty it.
3. Use the cleaning brush to clean the dustbin,and put back the HEPA
component.
4. Reinstall the dustbin close the top cover.
Dustbin
12
Routine Maintenance
1. Open the top cover to take out the dustbin,as shown
in the figure.
2. Open the HEPA component; take it ou t and empty it.
3. Use the cleaning brush to clean the dustbin,and put back the HEPA
component.
4. Reinstall the dustbin close the top cover.
Dustbin
12
28
Reinigung, Wartung und Aufbewahrung
• Reinigen das Gehäuse, die Stoßstange, die Ladekontakte
und die Anti-Fall-Sensoren mit einem fusselfreien, weichen,
trockenen Tuch. Reinigen Sie auch die Ladekontakte der
Ladestation.
• Entleeren und reinigen Sie regelmäßig den Staubbehälter
und den HEPA-Filter:
1. Entriegeln und entnehmen Sie den Staubbehälter.
Anti-Fall-Sensoren
2. Ö󰀨nen Sie die Abdeckung des Staubbehälters.
3. Entleeren Sie den Staubbehälter.
4. Reinigen Sie den Staubbehälter mit der Reinigungsbürste.