Instructions

12
Inbetriebnahme
Installieren Sie den Staubbehälter oder den Wassertank mit
integriertem Staubbehälter.
• Installieren Sie den Staubbehälter:
Setzen Sie den Staubbehälter in den Saugroboter ein.
• Installieren Sie den Wassertank:
1. Ö󰀨nen Sie die Befüllungsö󰀨nung und füllen den Was
-
sertank mit kaltem Leitungswassser.
2. Schließen Sie die Befüllungsö󰀨nung.
Routine Maintenance
1. Open the top cover to take out the dustbin,as shown
in the figure.
2. Open the HEPA component; take it ou t and empty it.
3. Use the cleaning brush to clean the dustbin,and put back the HEPA
component.
4. Reinstall the dustbin close the top cover.
Dustbin
12
3. Setzen Sie den Wassertank in den Saugroboter ein.
5
4. Install the 2-in-1 Water Tank
(1) Open the rubber cover of the water tank; fill the water tank with
water; then close the rubber cover.
(3) Attach the duster into the duster bracket and stick the duster
to the Velcro.
(4) Manually press the clips on both sides of the duster bracket,
and push the duster bracket to the bottom of the robot in the
indicated direction.
(2) Install the water tank into the robot in the indicated direction;
confirm that the clip is properly installed.
* Do not use cleaning products such as detergent, disinfectant and solid
cleaner to clean water tank in order to prevent corrosion and impair;
* Do not spray water to water tank or soak it into water;
* Do not use the water tank in the first cleaning;
* Do not use the water tank if the robot is unattended;
* Remove the water tank and duster bracket before charging the robot or
leaving it idle;
* If carpets are used in the house, please set virtual walls in the App.
Installation Instructions
5
4. Install the 2-in-1 Water Tank
(1) Open the rubber cover of the water tank; fill the water tank with
water; then close the rubber cover.
(3) Attach the duster into the duster bracket and stick the duster
to the Velcro.
(4) Manually press the clips on both sides of the duster bracket,
and push the duster bracket to the bottom of the robot in the
indicated direction.
(2) Install the water tank into the robot in the indicated direction;
confirm that the clip is properly installed.
* Do not use cleaning products such as detergent, disinfectant and solid
cleaner to clean water tank in order to prevent corrosion and impair;
* Do not spray water to water tank or soak it into water;
* Do not use the water tank in the first cleaning;
* Do not use the water tank if the robot is unattended;
* Remove the water tank and duster bracket before charging the robot or
leaving it idle;
* If carpets are used in the house, please set virtual walls in the App.
Installation Instructions